[1] –
→NOTE:
Approximate oil pan capacity is 2.9 L (3.1 qt.).
Drain oil.
[2] – Remove cap screws (G) from oil pan (D) and remove pan.
[3] – Remove cap screws (C) from strainer (A) and remove strainer and O-ring (B).
[4] – Clean and inspect all parts. Make sure that all gasket material has been removed from mating surfaces.
[5] – Install new O-ring (B) on strainer tube and install strainer (A).
[6] – Apply a thin bead of John Deere Form-in-Place Gasket to ladder frame.
[7] – Install pan (D), and cap screws (G). Tighten to specifications.
[8] – Fill engine with correct engine oil. (See Section 10, Group 15.)
