Cummins ISX11.9 CM2250 – Service Manual 011-027   Exhaust Gas Pressure Sensor Tube

NOTE: Removal of the sensor plumbing does not require sensor removal. Remove the sensor only if the sensor adapter is being replaced.

• Disconnect the electrical connector to the exhaust gas pressure sensor. Refer to Procedure 019-376 in Section 19.

Loosen the tube nuts at the exhaust manifold and at the sensor adapter.

Remove the tube.

WARNING  When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer’s recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury.

WARNING  Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury.

Inspect the inside of the tube. If the tube is clogged, use compressed air to remove debris or soot buildup.

Clean the outside of the tube with solvent.

Dry with compressed air.

Check the tube for cracks and thread damage. Replace the tube, if cracks or other thread damage is found.

Apply a film of high temperature anti-seize compound to the threads of the tube nuts.

Install the tube.

Connect and tighten the tube nuts.

Tighten the P-clip capscrew.

• Connect the electrical connectors to the exhaust gas pressure sensor. Refer to Procedure 019-376 in Section 19.
• Start the engine and verify proper operation.
• Use INSITE™ electronic service tool to check for fault codes.

If a malfunction resulted in coolant, oil, excessive fuel, or excessive black smoke entering the exhaust system, the aftertreatment system must be inspected. Refer to Procedure 014-013 in Section 14.