1. Remove the engine oil filter, fill with clean engine oil, and reinstall. Tighten: Tighten the oil filter to 24 N.m (18 lb ft). 2.…

1. Install the starter motor to the flywheel housing. NOTE: Refer to Fastener Notice. 2. Install the starter motor bolts. Tighten: Tighten the starter bolts…

1. Lightly lubricate the crankshaft balancer internal hub with engine oil. 2. Install the crankshaft balancer to the crankshaft. 3. Lightly lubricate the crankshaft balancer…

1. Install the pilot bearing. 2. Install the flywheel. NOTE: This component uses bolts with a preapplied molybdenum disulfide coating for thread lubrication. Do not …

1. Install the flywheel to the crankshaft. 2. Install the flywheel washer to the flywheel with the beveled side facing the engine. NOTE: This component…

J 44642 Crankshaft Rear Oil Seal Installer. See Special Tools . 1. Place the crankshaft rear oil seal onto the crankshaft. IMPORTANT: The J 44642…

1. Install the exhaust outlet. NOTE: Refer to Fastener Notice. 2. Install the exhaust outlet clamp. Tighten: Tighten the exhaust outlet clamp to 15 N.m…

1. Install the exhaust pipe with gaskets. 2. Install the exhaust outlet bracket. 3. Install the exhaust pipe to turbocharger bolts.  

1. Install the exhaust pipe with gaskets. 2. Install the exhaust pipe to turbocharger bolts. 4. Install the exhaust pipe heat shield. 5. Install the…

1. Apply a 2-3 mm wide by 0.5-1.5 mm high bead o f GM P/N 12378521 (Canadian P/N 88901148) sealant to the       …