Perform ail the steps in the procedure for dry clutch in stallation in addition to the following:
Coat the flywheel housing drain plug with pipe sealant and install in the hole in the bottom of the flywheel housing.
Tighten the plug.
Refer to the pipe plug torque values in Section 10 for different plug sizes.
Install the plastic plug in the tachometer drive access hole.
13 mm
Install the access plate and new gasket.
Install the capscrews and tighten.
Torque Value: 24 N»m [18 ft-lb]
Thoroughly clean the flywheel housing and cylinder block mating surfaces. These surfaces must be clean and free
of oil or debris.
NOTE: The capscrew holes on the mounging pads are drilled through. Coat set screws with LoctiteTM 277 and install into holes.
Apply a continuous bead of three bond around all cap screw holes on the mounting surface of the flywheel housing.
Coat the threads of the mounting capscrews with LoctiteTM 277.
Install and tighten the capscrews.
Torque Value: 60 N®m [45 ft-lb]
Install the plug into the barring gear hole.
