• NOTE: Bolts must contain a light film of oil on the bearing surface (under the head) and threads prior to assembly. • Step 1:…

• Step 1: Place the oil rail on top of the carrier so that the four single ball tubes are engaging the injector lead angle.…

• Step 1: Install bolts 1 through 8 finger tight. • Step 2: Torque bolts 9 though 16 to 8 lbf/ft (11 Nm). • Final…

• NOTE: Once bolts have been loaded to the initial value, they may not be reused. Use only new bolts. • Step 1: Torque the…

• NOTE: Once bolts have been loaded to the initial value, they may not be reused. Use only new bolts. • Step 1: Torque the…

Cylinder Balance Test: • Before using Cylinder Balance Test, Performance Diagnostic routines should be followed to insure no other             …