1. Using NEW gaskets, install oil cooler assembly onto cylinder block. Install and tighten oil cooler rear header-to-          cylinder block bolts…

1. Apply engine oil to NEW “O” rings and “O” ring mating surfaces. Install large “O” rings and then small “O” rings       …

1. Using soft-faced hammer, tap on oil cooler front and rear headers to loosen “O” rings. Remove oil cooler front and rear headers from oil…

1. Disconnect negative cables. Drain cooling system. See COOLING SYSTEM BLEEDING under REMOVAL &                  INSTALLATION. Raise and…

1. Install the inner gerotor. Lubricate the oil pump with clean engine oil. Position the outer gerotor in the oil pump         …

1. Inspect components for damage and wear. Install inner and outer rotors in low pressure oil pump body. Place             …

1. Low pressure oil pump is located on front cover. See Fig. 137. 2. Remove the crankshaft vibration damper. See CRANKSHAFT FRONT SEAL under REMOVAL…

1. Crankshaft-driven low pressure oil pump supplies pressurized lubrication for engine oiling system. See Fig. 137.          Oil cooler is used for…

1. High-pressure oiling system supplies oil pressure for fuel injector operation. See Fig. 72. During initial start or cold start, gear-driven high pressure oil pump…

1. Disconnect air intake tube and exhaust pipe from turbocharger. Rotate turbine wheel, shaft assembly and                   …