When removing the fuel feeding pumps A, with the rail holders B, pay attention that the sealing O-rings C remain in their seats. When refitting…
Category: KOHLER KDW 702
Depending on the engine model, the injection pump control rod will link two, three, or four injectors to the engine governor. Screws 1 and 2…
Important Setting should be performed when the engine is cold. Bring each cylinder piston to top dead center on the compression stroke and set clearance…
For KDW 702-1003-1404 engines, the exhaust gases exit from the cylinder head cover (see Fig. 53, 54). Remove the cover, check the integrity of the…
Components: 1 Gland Nut 2 Bushing 3 Body 4 Diaphragm 5 Cap / Cover 6 Clip / Lock 7 O-Ring 8 Washer 9 O-Ring 10…
The rocker arm cover gasket A ensures the seal of the lubrication circuit for the camshaft and rocker arm shaft. Always replace it and mount…
The engine control components are all on the cylinder head. The cover contains part of the lubrication duct of the camshaft and of the rocker…
The pump rotors should be coupled on the same side, see references 2 and 3. Replace the O-ring 1. Tighten the fastening screws to the…
KOHLER therefore recommends that the oil pump be handled as an assembly from a service standpoint KOHLER does not recommend that the oil pump be…
Caution – Warning While reassembling, check the integrity of the components and check that they operate correctly. Bad operation of the speed governor can cause…