#042 Inspection of stop lamp switch • If any fault is found, replace the switch. #302 Inspection of brake fluid pressure sensor • Apply voltage…

Installation sequence Follow the removal sequence in reverse. Repair kit: Service Kit A (Part No.: MK443502), Service kit C (Part No.: MK443504) Work before removal…

Work before installation Draining of coolant • Perform draining of coolant in the high voltage cooling system. (See “ON-VEHICLE INSPECTION AND ADJUSTMENT”.) Installation procedure •…

[Removal] • Remove the cover. • Remove the air filter by pulling it out while lifting it. [Inspection] • Check the air filter and clean…

• Open the radiator drain cock to drain coolant around the radiator. • Disconnect the water hose (between the motor electronic control unit and the…

• After driving, check the radiator, reservoir tank, water pump, water hose, motor electronic control unit, etc. for coolant leakage with the engine idling. •…

• Inspection should be performed before starting the engine when the coolant is cold. • Check that the coolant level in the reservoir tank is…

• These inspections aid troubleshooting by enabling you to check whether electronic control unit signals are being correctly transmitted via the vehicle harness and connectors.…