Loosen the screws and remove the cover 1. Check gasket ring 2 for integrity. Remove the drive rod from the fuel pump. Gently remove the…

To remove pivot 1 from the support 2 it’s necessary to drill out pin 3 using a 4mm drill bit. On remounting insert a new…

When the removal (but not replacement) of a unit injector is required the following procedure may be used to avoid the need for other adjustments:…

Non-return valve A immediately stops the engine whenever the stop is activated. Note: If the value of B is not achieved, the two rings C…

When removing the fuel feeding pumps A, with the rail holders B, pay attention that the sealing O-rings C remain in their seats. When refitting…

Depending on the engine model, the injection pump control rod will link two, three, or four injectors to the engine governor. Screws 1 and 2…

Important Setting should be performed when the engine is cold. Bring each cylinder piston to top dead center on the compression stroke and set clearance…

For KDW 702-1003-1404 engines, the exhaust gases exit from the cylinder head cover (see Fig. 53, 54). Remove the cover, check the integrity of the…

Components: 1 Gland Nut 2 Bushing 3 Body 4 Diaphragm 5 Cap / Cover 6 Clip / Lock 7 O-Ring 8 Washer 9 O-Ring 10…

The rocker arm cover gasket A ensures the seal of the lubrication circuit for the camshaft and rocker arm shaft. Always replace it and mount…