1.Disconnect and isolate the negative battery cable. 2. Remove the cylinder head. Refer to CYLINDER HEAD, REMOVAL. CAUTION: If the lifter and retainer assembly are…

1. To determine source of lifter noise, crank the engine with cylinder head covers removed. 2. Feel each valve spring or rocker arm to detect…

Before disassembling any part of the engine to correct lifter noise, check the oil pressure. If the vehicle has no oil pressure gauge, install a…

1. Position the flex plate (1) onto the crankshaft and install the bolts finger tight. 2. Using the sequence shown in illustration, tighten the flex…

1. Remove the transmission. Refer to REMOVAL . 2. Using the sequence shown in illustration, remove the flex plate (1) retaining bolts. 3. Remove the…

1. Using (special tool #10387, Installer, Vibration Damper), install the threaded rod (1) onto the crankshaft (2). 2. Tighten the threaded rod (4) until it…

1. Disconnect the negative battery cable (1). 2. Drain the cooling system. Refer to STANDARD PROCEDURE . 3. Remove the upper radiator hose clamps (1)…

The crankshaft damper is used to control the resonance that is produced by the engine. The Noise, Vibration, and Harshness (NVH) created from the crankshaft…

CAUTION: If the engine encounters a catastrophic failure, the engine oil cooler must be replaced or damage to the new engine and/or components could result.…

CAUTION: If the engine encounters a catastrophic failure, the engine oil cooler must be replaced or damage to the new engine and/or components could result.…