NOTE: Refer to the OEM service manual for removal procedures. Remove the hydraulic pump and gear assembly.  

Install the accessory drive and new gasket. NOTE: When installing the accessory drive and gasket, make sure the oil supply hole in the gear housing…

Rear Gear Train NOTE: If oil supply to the accessory drive is not required and the gasket does not have oil passages, this check is…

Use gauge, Part Number 3824564, and magnetic base, Part Number 3377399 to check the accessory drive gear end play. If the end play is out…

Use a hydraulic press and proper support to assemble the accessory drive in the following order: • Press the accessory drive shaft into the bearing,…

If damage was found to a component of the accessory drive during the Clean and Inspect for Reuse step, the following components of the accessory…

Remove any residual gasket material from the mounting surfaces of the accessory drive, driven accessory/ hydraulic pump, and, if equipped, the cover plate surface. NOTE:…

Remove the two capscrews securing the accessory drive to the rear gear housing. Remove the accessory drive and gasket.  

Rear Gear Train Install the idler pulley assembly and idler pulley support bracket mounting capscrews Tighten the capscrews. Torque Value: 18 N•m [ 159 in-lb…

Rear Gear Train Install the idler pulley onto the idler shaft. For idler pulley installations in which the idler pulley shaft is not part of…