A pressure will be incorporated in the filter base. It will be used to indicate filter blockage. The pressure differential value is set at 14…

The 6.2L uses a water in fuel warning system, which allows the user to guard against water in the fuel. The water is detected by…

The bottom of the filter is a hollow water collector. (See Figure 4-19). Because of the greater density of the water, the water droplets will…

The engine fuel filter is a two-stage pleated paper type filter (Figure 4-20). The first stage consists of approximately 350 sq. inches of filtering area…

See Figure 4-19. The purpose of the heater is to heat fuel, so that the filter does not plug with parafin wax crystals. This will…

Combination Fuel Heater Fuel Filter Water Separator Water Sensor Filter Change Signal

The G-P series uses a Stanadyne Model 75 secondary fuel filter in 1983. See Figure 4-16. It is fastened using two bail clips. It is…

The 1982 C, K & P, and the 1983 C, K trucks use an intake manifold mounted secondary fuel filter, before the fuel enters the…

A Diesel cold weather package is used. This package consists of an in-line diesel fuel heater and the engine block heater. (Figure 4-14). The purpose…

See Figure 4-13. If it should become necessary to drain water from the fuel tank, also check the primary fuel filter for water. This can…