Install all accessories and brackets that were removed from the previous engine. NOTE: On applications where the rear engine mounts are attached to the transmission,…

Inspect all rubber-cushioned mounts for cracks or dam­age. Inspect all mounting brackets for cracks or damaged bolt holes. NOTE: Damaged engine mounts and brackets can…

General Information The procedures required to replace an engine will vary with different engine models, the type of equipment, op­tional equipment, and the shop facilities.…

Remove all belts from the engine. Cover the following parts of the engine: • All pulley belt surfaces • Exhaust and intake openings • Electrical…

On-High way Caution: Refer to General Engine Test Procedures – (Chassis Dynamometer) (8-05) before operating the en­gine to avoid internal component damage. Operate the engine…

Caution: Refer to General Engine Test Procedures – (Chassis Dynamometer) (8-05) before operating the en­gine to avoid internal component damage. NOTE: Refer to Chassis Dynamometer…

The following procedure assumes that the lubricating oil and fuel systems were correctly primed, the dipstick cal­ ibrated, and the engine filled to the correct…

The performance of an engine installed in on-highway vehicles can be tested on a chassis dynamometer. NOTE: Due to driveline efficiency and engine-driven acces­sories, the…

Make sure the air compressor will be unloaded during the performance check. Apply regulated air pressure of 655 kPa [95 psi] to the air compressor…

The engine run-in period allows the tester to detect assembly errors and to make final adjustments needed for performance that meets specifications. NOTE: The amount…