Insert the dowels through the push tube holes and into the top of each tappet securely. When properly installed, the dowels can be used to…

Install a new seal in the gear cover. Refer to Procedure Apply a thin bead of Three-BondTM to the cover side of the front cover…

Clean the gear cover and gear housing gasket surface. Inspect the gear cover for cracks or damage. Caution: The crankshaft must be clean, dry and…

Remove the drive belt. 15 mm Remove the crankshaft pulley. 10 mm If required remove the fan hub pulley. 10 mm Remove the front gear…

Preparatory Step; • Remove the transmission. • Remove the flywheel. 1/8 inch Drill Drill two holes 180 degrees apart into the seal carrier. No. 10…

Apply a bead of Loctite 277 or equivalent to the outside diameter of the seal. Leave the plastic pilot installation tool in the lubricating oil…

Clean the gear cover seal bore and the crankshaft surface free of all oil and seal residue. Inspect the crankshaft for excessive wear. NOTE: If…

Remove the drive belt. NOTE: Removal is easier if the crankshaft pulley is loosened before removing the belt. 15 mm Remove the crankshaft pulley. Remove…

Check the mounting web for cracks. Check the housing for dents or raised surfaces. Replace the damper if any of these defects are identified. Refer…

Check the index lines (A) on the damper hub (B) and the inertia member (C). If the lines are more than 1.59 mm [1/16 inch]…