Installation sequence Follow the removal sequence in reverse. • After installation, measure and adjust the boost pressure. (See “ON-VEHICLE INSPECTION AND ADJUSTMENT”.) Installation procedure •Installation:…
Author: samuel
Assembly sequence Follow the disassembly sequence in reverse. Cleaning, inspection procedure Cleaning: Element • Blow a jet of compressed air at a pressure not higher…
#038 Inspection of parking brake switch • Measure continuity between terminals 1 and 2 (body) ground. • If any fault is found, replace the switch.…
• These inspections aid troubleshooting by enabling you to check whether electronic control unit signals are being correctly transmitted via the vehicle harness and connectors.…
• It is possible to see service data and actuator tests simultaneously.
• It is possible to see service data and actuator tests simultaneously.
3.1 Diagnosis code list • Diagnosis codes shown by the Multi-Use Tester and those indicated by flashing of the warning lamp are different. • The…
• Before measuring voltage, check the battery for charged condition and specific gravity. If system inspection is performed with the battery uncharged or reduced in…