Table of Contents Install Install TOC Install the oil fill tube, new o-ring, and capscrews. Torque Value:  47  n.m  [35 ft-lb] SMALL | MEDIUM | LARGE Next Install the oil fill covers, new…

Table of Contents Install Install TOC Install the front lubricating oil transfer cover gasket and four mounting capscrews. Torque Value:  47  n.m  [35 ft-lb] SMALL | MEDIUM | LARGE Last Modified:  22-Jun-2010 Feedback /…

Table of Contents Install Install TOC  WARNING  This component or assembly weighs greater than 23 kg [50 lb]. To prevent serious personal injury, be sure…

Table of Contents Install Install TOC Use Lubriplate™ 105, or equivalent, to coat the upper thrust bearings. SMALL | MEDIUM | LARGE Next Push the crankshaft toward the rear…

Table of Contents Install Measure Install TOC  CAUTION  The cylinder block saddle and the cap mating surfaces must be clean and dry when the bearing…

Table of Contents Install Install TOC  CAUTION  The liners must be installed within 30 seconds after being lubricated with oil. If the liners are not…

Table of Contents Remove Remove TOC The cylinder liners can be removed by using cylinder liner remover, Part Number 3163745, and cylinder liner remover plate,…

Table of Contents Remove Remove TOC NOTE: Cummins Inc. recommends replacing the thrust bearings when the main bearings are replaced. Refer to Procedure 001-007 in Section…

Table of Contents Remove Remove TOC Remove the thrust bearings from the Number 4 main bearing cap. Mark the thrust bearings as being lower, and…

Table of Contents Remove Remove TOC  WARNING  This component or assembly weighs greater than 23 kg [50 lb]. To prevent serious personal injury, be sure…