Shut off the engine. Open the draincock on the wet tank to release air from the system. Close the draincock after the pressure is released.…

If the air pressure is being governed at either a higher or lower pressure than the equipment manufacturer’s specification, connect a regulated shop air pressure…

The air compressor governor location can vary. The air governor can be air compressor mounted or chassis mounted. For air compressor governor specifications, removal, and…

Install the “ping” tank. Install the three “ping” tank to fuel filter bracket mounting capscrews. Tighten and mounting capscrews. Torque Value: 24 N•m [ 212…

NOTE: For the OEM installed discharge line inspection of carbon buildup. Refer to Procedure 012-003 in Section 12. Clean the air compressor discharge line and…

NOTE: Apply a counter-torque to the air compressor discharge fitting when loosening the discharge line. Disconnect the air compressor discharge line between the air compressor…

The air discharge line is supplied and connected directly to the engine’s air compressor by the vehicles OEM. For some applications, a noise reduction tank…

For Wabco air compressors use the following procedure: Prior to installing the air compressor, identify which gasket is going to be installed so that, if…

NOTE: To make sure the air compressor does not contribute to engine vibrations when installed, the air compressor must be properly timed to the engine.…

Install the cylinder block mounting bracket and mounting fasteners. Tighten the mounting fasteners finger-tight. NOTE: Make sure the drive gear and air compressor drive shaft…