A pressure-vent cap is used on the cross-flow radiator to allow a buildup of 103 kPa (15 psi) in the cooling system. This pressure raises…
Category: 62L-V8
See Figure 2-51. The radiator holds a large volume of coolant in close contact with flowing air. This allows the radiator to transfer heat from…
1. NOISE Fan noise is sometimes evident under the following normal conditions: a. When clutch is engaged for maximum cooling. b. During first few minutes…
There are two viscous clutch members (Figure 246). The clutch plate is splined to the pulley shaft and becomes the driving member. The driven member…
The 6.2L Coolant Fan is not directly driven. The engine fan is mounted on the water pump shaft and is driven by the same belt…
The engine cooling system is similar to that used in a gasoline engine, except that it is larger capacity. (See Figure 2-43). The purpose of…
The vacuum pump (Figure 2-37) is required because the diesel engine does not develop vacuum in the unrestricted air intake manifold. Since the air crossover…
1. Surface must be clean and dry. Remove all traces of oil and old gasket material. Clean with a chlorinated solvent such as carburetor spray…
During late 1983 Model Year production, a vented oil fill tube (14071059) replaced the non-vented tube (Figure 2-35). The vented tube will prevent the possibility…