Perform ail the steps in the procedure for dry clutch in­ stallation in addition to the following: Coat the flywheel housing drain plug with pipe…

Caution: The dial indicator tip must not enter the cap­ screw holes or the gauge will be damaged. Install a dial indicator as illustrated. NOTE:…

Attach a dial indicator to the crankshaft. The dial indicator can be mounted by any method that holds the extension bar of the indicator rigid…

Install rectangular seal and lubricate with Lubriplate® 105. Visually inspect the rear face of the cylinder block and flywheel housing mounting surface for cleanliness and…

Warning: When using a steam cleaner, wear protective clothing and safety glasses or a face shield. Hot steam can cause serious personal injury. Use steam…

Remove the transmission, clutch and all related compo­nents (if equipped). Refer to the manufacturer’s instructions. Remove the flywheel/ring gear assembly. Refer to Pro­cedure (7-23). Adequately…

NOTE: Do not use any kind of lubricant to install the seal. The oil seal must be installed with the lip of the oil seal…

Clean the gasket surface of the cylinder block and rear cover. Use a crocus cloth to remove any rust or other deposits from the crankshaft…

If the crankshaft seal has worn a groove in the crankshaft flange, a wear sleeve must be installed to prevent oil leakage. Disconnect the driveline…

Note: Cummins 4BT flywheel torque value is 137 N«m [101 ft-lb] Use two capscrews in the front of the crankshaft, or sim­ilar device, to hold…