18 mm Remove the flywheel. Brass Drift Pin Warning: Wear eye protection when you drive the gear from the flywheel. Do not use a steel…

NOTE: Omit this step if the removed gear housing was installed; proceed to page 7-143 and complete the installa­tion of the rocker levers. The location…

Mark and trim 1.59 mm [1/16 inch] off of the new gear housing gasket. NOTE: When properly trimmed, the gear housing gasket should be even…

If the gasket is tom, it may be repaired. Cut the torn gasket off even with the front of the cylinder block. Using the old…

Clean the gasket material from the cylinder block. Inspect the lubricatin oil pan gasket. If it is not torn, coat with Three Bond 1207-C® sealant.…

Preparatory Steps: • Remove the valve cover rocker levers and push rods. • Remove the vibration damper. Refer to Procedure (7-15). • Remove the camshaft.…

1/2 inch Drive, 3377371, Engine Barring Gear Locate Top Dead Center (TDC) for Cylinder Number 1 by barring crankshaft slowly while pressing on the engine…

Install the key. Lubricate the camshaft surface with Lubriplate 105 or equivalent. Caution: The camshaft gear will be permanently dis­torted if overheated. The oven temperature…

Inspect the camshaft bore for fretting or burrs. NOTE: If the fretting, burrs or raised material cannot be removed with Scotch-Brite® 7448 or equivalent, replace…

Remove the fan pulley. Remove the crankshaft pulley. Refer to Procedure (7-15). Remove the gear cover. Refer to Procedure (7-18). Remove the camshaft. Refer to…