Steam clean or use solvent, and dry the parts with compressed air. Visually inspect the engine mounts for cracks or deterioration. If cracks or deterioration…

The following tools are needed to perform this procedure: • Drill ream fixture, Part No. ST-1232, which contains: (1) Plate, Part No. ST-1232-1 (2) Locator…

Steam clean or use solvent to clean the housing. Dry with compressed air. Visually inspect all surfaces for nicks, burrs, or cracks. Use a fine…

Heat the outside diameter of the ring gear with a heating torch. Use a blunt chisel and a hammer to remove the gear from the…

Cleaning Use a wire brush to clean the crankshaft pilot bore. Steam clean or use a solvent, and dry with compressed air. Inspection Visually inspect…

Remove the heavy paper and tape from the openings. Remove the warning tag. Use clean diesel fuel to flush the preservative oil from the fuel…

This procedure describes the proper method to prepare an engine for long term storage (6 to 24 months). NOTE: After 24 months in storage, the…

Remove the tape from the openings. Remove the warning tag. Replace the oil, water, and fuel filters. Prime the lubricating oil system. Refer to Priming…