NOTE: This procedure describes the proper method to prepare an engine for short term storage (1 to 6 months). Operate the engine at ‘‘High Idle’’…

Cover the following: • Exhaust and Intake Openings • Electrical Components • Fuel Inlet and Drain Connections • Any Exposed Fittings, Threads and Electrical Wire…

On-Highway Caution: Refer to General Information and General Engine Test Specifications and Procedures before operat- ing the engine to avoid internal component damage. Operate the…

NOTE: Refer to Chassis Dynamometer Operation, Procedure 14-04, for general operating procedures and safety precautions. NOTE: Operate the vehicle in a gear that produces a…

Use coolant pressure/temperature/flow analyzer kit, Part No. 3822994, to measure engine coolant pressure. Maximum coolant pressure (pressure cap removed) with closed thermostat is 317 kPa…

Use Pressure Gauge, Part No. 3375275, to measure lubricating oil pressure. Install the pressure gauge to the main oil rifle and observe the oil pressure.…

Measure the engine crankcase pressure. Use blowby checking tool, Part No. 3375150, and water manometer, Part No. ST-1111-3. Install a plug in the crankcase breather…

Measure the exhaust air restriction. Install the vacuum gauge, Part No. ST-1273, or a manometer in the exhaust air piping. NOTE: The gauge adapter must…

Measure the inlet air restriction. Install the vacuum gauge, Part No. ST-434, or a manometer in the intake air piping. NOTE: The gauge adapter must…

Measure the intake pressure drop across the charge air cooler. This test can be done with a mercury manometer or two separate gauges, Part No.…