Symptom Fuel aeration will exhibit one or more of the following characteristics: • Engine stall during operation • White to black smoke during cranking •…

Symptom Combustion leaks can be identified by coolant overflowing from deaeration tank or air bubbles in the coolant. Cause • Failed injector sleeve • Failed…

Reset the change engine oil message feature as follows: 1.Set the parking brake (required for correct ESC signal). 2. Turn ignition switch to ON. NOTE:…

1. Turn the ignition switch to ON. 2. Select PP_ServiceInterval.ssn from the Open Session File window, and select OPEN to open Vehicle       …

Key-On Engine-Off Tests Standard Test The KOEO Standard test is done by the ECM. The technician runs this test, using the EST or the CRUISE…

Using EST Accessing Diagnostic Trouble Codes (DTCs) NOTE: When opening VIN+ session to fill out form heading, the DTC window automatically appears. 1. Turn the…

Continuous Monitor Continuous Monitor is a series of continuous diagnostic tests done by the Electronic Control Module (ECM) to detect failure modes (Out of Range,…

Road Speed Limiting Road speed limiting limits the speed to the maximum vehicle speed programmed by the customer. Cruise Control The ECM controls the cruise…

Electronic Governor Control International® engines are electronically controlled for all operating ranges. American Trucking Association (ATA) Datalink Vehicles are equipped with the ATA datalink connector…

The ECM monitors the following criteria to make sure certain conditions are met. • ABS (inactive) • RPM (greater than 1200) • APS (less than…