1. Place the cam plate on the surface plate. 2. Use a feeler gauge of 0.3 mm (0.012 in.) thick for judgement of the cam…

1. Move the brake cam lever by hand to check the movement. 2. If the movement is heavy, refine the brake cam with sandpaper.  

1. Remove the nut (1) on the brake cam (6). 2. Remove the brake cam (6) and brake cam lever (4). (When reassembling) • Apply…

 It is possible to disassemble as shown in the figure above. (When reassembling) • Place the brake discs (4) so that the hole (A)…

1. Remove the suction pipe (1). 2. Remove the brake rod (2). 3. Separate the brake case (4), tapping the brake cam lever (3). (When…

1. Loosen and remove the rear axle case mounting screws and nuts. 2. Support the rear axle case (1) with the nylon lift strap and…

1. Remove the fender (R.H.) (1). 2. Remove the grip (2) and the fender support assembly (3). 3. Follow the same procedure as above for…

1. Disconnect the 4P connector (1) and the 1P connector (2). 2. Remove the seat switch (3) from seat adjuster and disconnect the 3P connector…

1. Place the disassembling stand under the transmission case. 2. Remove the ROPS upper frame (1). 3. Remove the ROPS lower frame (2). 4. Loosen…

1. Remove the top link (1). 2. Remove the rubber spring (2), the lift rod (3) and the lower link (4).