1. Verify the MDS solenoid bores are free of debris before installing the MDS solenoid into the engine block.
2. Install the MDS solenoid(s) (3), ensure the seal is fully seated into the engine block.
3. Install the retaining bolt(s) (3) and tighten to 11 N.m (8 ft. lbs.).
4. Connect the MDS electrical connector to the solenoid(s) (1).
5. Install the foam insulator pad (1).
6. Install the intake manifold. Refer to MANIFOLD, INTAKE, INSTALLATION.
7. Connect the negative battery cable (1).
