6.7L Cummins Electrical Equipment – Starter Solenoid – Initial Check

Before troubleshooting the starter motor, make sure the battery terminals are not loose or corroded. Refer to
Procedure 013-009 in Section 13.

6.7L Cummins Cylinder Block - Initial Check
Prior to removing the piston and connecting rod assemblies, measure and record piston protrusion. Refer…
Cummins 4BT - Solenoid Resistance Check
The synchro-start solenoid can be checked using a voltohmmeter. Disconnect the wiring harness and check…
6.7L Cummins Electrical Equipment - Batteries - Initial Check
If conventional batteries are used, remove the cell caps or covers, and check the electrolyte…
6.7L Cummins Exhaust System - Exhaust Restriction - Initial Check
Use INSITE'M electronic service tool to check for fault codes. If any faults are present,…
6.7L Cummins Drive Units - Accessory Drive - Initial Check
Rear Gear Train NOTE: If oil supply to the accessory drive is not required and…

Published by samuel