Rocker Lever Cover Mounted Crankcase Breather
If the gasket was removed, install the gasket into the rocker lever cover groove, starting with the tab end first.
Then install the corners opposite the gasket tab end.
Finish by pushing in the sides (see illustration).
Gently push the gasket down into the groove. Do not use a finger to trace the gasket around into the groove during
installation, as this will stretch the gasket, making it difficult to fully seat into the groove.
Do not cut the gasket to make it fit into the groove, as this will result in an oil leak.
The gasket must be fully seated around the entire perimeter of the rocker lever cover groove.
Apply clean 15W-40 engine oil to the a-rings on the crankcase ventilation filter.
Install the filter onto the rocker lever cover.
Install the crankcase ventilation filter cover. Make sure the closed crankcase ventilation valve port is seated on the
filter outlet connection.
Install the filter cover capscrews.
Tighten the capscrews, starting with the inner-most capscrews and working outward in a circular manner.
Torque Value: 7 N•m [ 62 in-lb ]
Install the oil fill cap.
Rear Engine Mounted Crankcase Breather
NOTE: Due to limited access to the crankcase ventilation filter cover capscrews, it may be necessary to assemble
the crankcase ventilation housing before installation on some applications.
Install the filter into the crankcase ventilation filter housing.
Install the filter cover and capscrews.
Tighten the capscrews, starting with the inner-most capscrews and working outward in a circular manner.
Torque Value: 7 N•m [ 62 in-lb ]
