• Wire brush head bolts to clean threads.
• Apply P/N 1052080 sealant to bolt threads.
• Oil underneath head of bolts.
• Dowel pins hold head off block.
• Dowel pins off location.
• No dowel pins.
• Cylinder heads warped more than .006 inches longitudinally and .003″ transversely.
• Pre-chamber + .002″ inches from head (.004″ maximum)
• No damage in sealing ring area.
• No stamps in seal area around water passage.
• Water passage seal surrounds all water passages.
• No chips in bolt holes.
• Bolt holes in cylinder block drilled and tapped deep enough.
• Follow torque sequence and installation torque procedure.
