KUBOTA – L2501 – TRANSMISSION – CHECKING AND ADJUSTING – Adjusting Cruise Control Rod (Option)

1. Set the cruise control lever to fully forward.
2. Adjust the cruise control rod (1) so that trunnion shaft may maximum incline forward.

KUBOTA - L2501 - TRANSMISSION - CHECKING AND ADJUSTING - Adjusting Neutral
1. Disengage the front wheel drive lever. (Drive only rear wheels.) 2. Set the cruise…
KUBOTA - L2501 - TRANSMISSION - CHECKING AND ADJUSTING - Adjusting PTO Wire
1. Check to see that the threaded portion of wire (3) rear side is set…
KUBOTA - L2501 - TRANSMISSION - CHECKING AND ADJUSTING - Checking Cruise Lever Operating Force (Option)
1. Push the cruise control lever (1) into maximum tied position. After that pull it…
KUBOTA - L2501 - ENGINE - Push Rod Alignment
1. Place the push rod on V blocks. 2. Measure the push rod alignment. 3.…
KUBOTA - L2501 - ENGINE - Connecting Rod Alignment
1. Install the piston pin into the connecting rod. 2. Install the connecting rod on…

Published by samuel