KUBOTA – L2501 – ELECTRICAL SYSTEM – CHECKING AND ADJUSTING – LIGHT SWITCHES AND FLASHER UNIT – Remove the Combination Switch

1. Remove the steering wheel and rear bonnet and disconnect 8P connector (2) after turning the main switch OFF position.
2. Perform the following checkings.

KUBOTA - L2501 - ELECTRICAL SYSTEM - ENGINE STARTING SYSTEM - SAFETY SWITCH - PTO Switch
PTO switch (2) is mounted on the PTO shift lever stay. It serves as a…
KUBOTA - L2501 - ELECTRICAL SYSTEM - ENGINE STARTING SYSTEM - SAFETY SWITCH - HST Switch
HST switch (1) is mounted on the holder with steering support (2). When the HST…
KUBOTA - L2501 - ELECTRICAL SYSTEM - ENGINE STARTING SYSTEM - SAFETY SWITCH - Clutch Switch
Clutch switch (1) is mounted on the bracket (2) with the clutch housing case (3).…
KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - Connector Voltage
1. Measure the voltage with a voltmeter across the connector B terminal and chassis. 2.…
KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - Checking Fuse
1. Check the fuse. 2. If any of the fuses is blown, replace it with…

Related Posts

Published by samuel