NOTE: Use the engine rebuild stand, Part No. 3375194, and the adapter plate, Part No. 3375013.
Use six 5/8 – 11 X 1 3/4-inch grade 5 capscrews to install the adapter plate to the rebuild stand.
Torque Value: 102 N•m [75 ft-lb]
Install the mounting plate adapter on the rear water header if removed during the cleaning or inspection procedure. Use five 1/4-20 X 1 1/4-inch capscrews to mount the adapter.
Torque Value: 10 N•m [7 ft-lb]
Install three 1/2-13 X 3 3/8-inch capscrews through the adapter plate as shown.
Install the three adapter plate spacers over the capscrews.
Use a nylon lifting sling, Part No. 3375957, (with a leather sleeve), to lift the cylinder block.
Put the oil cooler side of the cylinder block to the adapter plate of the rebuild stand.
Align the mounting hole in the adapter plate (1) with the capscrew hole (2) in the mounting plate adapter.
Use one 5/8-11 X 1 3/4-inch grade 5 capscrew to mount the adapter plate to the mounting plate adapter. Use your fingers to tighten the capscrew.
Adjust the position of the cylinder block so that the remaining mounting holes in the adapter plate (2) and (3) align with the capscrew holes in the cylinder block.
Use your fingers to tighten the three 1/2-13 X 3 3/8-inch capscrews (2).
Install four 3/8-16 X 3 3/8-inch capscrews in the location shown (3). Use your fingers to tighten the capscrews.
Tighten all of the adapter plate mounting capscrews in the sequence shown.
Torque Value:
3/8-inch 41 N•m [30 ft-lb]
1/2-inch 102 N•m [75 ft-lb]
5/8-inch 102 N•m [75 ft-lb]
