NOTE: This procedure assumes that the roller is removed.
Use a pin punch to remove the socket.
NOTE: The roller must be removed to allow access to the socket removal hole. Refer to Cam Follower Lever – Roller
Replacement (04-03).
The N14 valve and injector cam follower socket has an identification groove around the outside diameter and two
marks 180 degrees apart on top of the socket.
Measure the parts.
Caution: Support as shown to prevent cracks in the cam follower. An old roller can be used to support the lever.
Use a brass drift or a used push rod end (2). Use an arbor press. Install the new socket. The socket must touch the
bottom of the bore in the lever.
