Refer to “ Diagnosis of Starter Motor Noise.” PINION CLEARANCE (Gas Engines) 1. Remove the lower flywheel housing cover. 2. Inspect the flywheel for signs…
Author: samuel
BATTERY Determine the condition of the battery. Refer to SECTION 6D1 for battery diagnosis and testing. WIRING Check the 10-amp CRANK fuse. Inspect the system…
Refer to figures 8 and 9 for diagnosis of the cranking system. Before removing any component in the system for repair, make the following checks.…
Three starter motors are used on these engines. The SD-260 is a straight drive starter with the pinion driven directly by the armature shaft. Pole…
The cranking circuit consists of the battery, starter motor, ignition switch (gasoline engines), engine control switch (diesel engines), neutral start switch (manual transmission), and related…
Additional ground straps are used to connect the body and frame to the engine and transmission. Always connect all ground straps to ensure a good…
Excessive resistance caused by poor terminal connections and partial short circuits through worn cable insulation will result in an abnormal voltage drop in the starter…
Remove or Disconnect (Figures 11 and 12) 1. Negative cable from the negative battery terminal. 2. Positive cable from the positive battery terminal. 3. Battery…
Do not try to jump start a vehicle i f you are unsure of the other vehicle’s voltage or ground, or if the other vehicle’s…