A vacuum pump is located on the front right side of the engine and provides a vacuum source to operate the EGR system for the…
Author: samuel
The crankcase ventilation system is designed to reduce the crankcase pressure at idle. This lower pressure reduces engine oil leaks. The system consists of a…
The removal and installation instructions serve only as a guide. Additional operations may be required on some vehicles to remove other equipment to gain access…
This test requires both a fully charged battery and a generator test stand to operate the generator. 1. Make connect i ons as shown in…
Tool Required: J 39200 Digital Multimeter 1. Check the belt for wear and tension. Refer to SECTION 6B1 for belt diagnosis. Check the wiring. 2.…
Trouble in the charging system will show up as one or more of the following conditions: • Abnormal indicator lamp operation. • A high or…
Before performing the diagnosis procedures on the vehicle, make sure the system wiring is good and the belt is not slipping. Also, the battery must…
Noise from a generator may be caused by a loose drive pulley, loose mounting bolts, worn or dirty bearings, worn stator, or worn rectifier bridge.…
The CS-130 (figure 1) generator features a high ampere output per pound of weight The CS stands for charging system and 130 is the measurement…
Remove or Disconnect (Figures 12, 13,-14, and 15) 1. Negative battery cable. Refer to CAUTION on page 6D2-1. 2. Starter brackets and/or shields, if equipped.…