Table of Contents Initial Check Initial Check TOC  CAUTION  The fan shroud must be installed correctly, be in good condition, and the shroud-to-fan clearance must…

Table of Contents Preparatory Steps Remove Clean and Inspect for Reuse Install Finishing Steps Preparatory Steps TOC Remove the cooling fan. Refer to Procedure 008-040…

Table of Contents Initial Check   With Low Temperature Fan-On Control With High Temperature Fan On Initial Check TOC With Low Temperature Fan-On Control  CAUTION …

Table of Contents General Information General Information TOC Always use good quality, soft water in the coolant mixture. Water added to the cooling system must…

Table of Contents Pressure Test Pressure Test TOC Use a pressure gauge with a maximum capacity of 414 kPa [60 psi]. Measure the coolant pressure…

Table of Contents Initial Check   Air in Cooling System Leak Test   Fan, Shutter, or Heater Air Control Valve Air Compressor Combustion Gas Leak…

Table of Contents Drain Flush Fill Pressure Test Drain TOC Position the equipment on level ground.   SMALL | MEDIUM | LARGE Next  WARNING  Do not remove the pressure…

Table of Contents Initial Check Initial Check TOC The cooling system must be designed to allow air to escape while filling the coolant system. SMALL | MEDIUM | LARGE…

Table of Contents Preparatory Steps Inspect for Reuse Remove Install Finishing Steps Preparatory Steps TOC  WARNING  Do not remove the pressure cap from a hot…

Table of Contents Preparatory Steps Remove Inspect for Reuse Install Finishing Steps Preparatory Steps TOC  WARNING  Do not remove the pressure cap from a hot…