Table of Contents Remove Remove TOC Remove the six filter head mounting capscrews and the filter head. Remove and discard the gasket. NOTE: To remove the…

Table of Contents Remove Remove TOC Clean the area above the lubricating oil cooler to prevent debris entry into the oil passages. SMALL | MEDIUM | LARGE Next Remove…

Table of Contents Remove Remove TOC Remove the three pump drive mounting capscrews. Install a slide hammer and the engine baring tool, Part Number 3824270,…

Table of Contents Remove Remove TOC NOTE: This section is for the hydraulic drive front gear cover option. Remove the remaining gear cover mounting capscrews and…

Table of Contents Remove Remove TOC Remove the rocker housing mounting capscrews. Remove the rocker housing. Discard the gasket and five grommet seals. SMALL | MEDIUM | LARGE Last…

Table of Contents Remove Remove TOC Disconnect the engine harness from the internal actuator harness connector at the rocker lever housing. The internal actuator harness…

Table of Contents Remove Remove TOC If possible, provide a work area that will not have flying debris or dust.  Gently place the removed injector(s)…

Table of Contents Remove Remove TOC Remove the fuel connector retaining nut. Remove the fuel connector from the cylinder head. Used fuel connectors must be…

Table of Contents Remove Remove TOC NOTE: Make note of the crosshead location and orientation. If the crossheads are reused, they must be installed in their…

Table of Contents Remove Remove TOC NOTE: There are two rocker lever shaft assemblies: front and rear. This includes unique exhaust and intake rocker levers for…