CAUTION: The longer push rods are for the exhaust side, and the shorter push rods are for intake side. 1. Install the push rods in…

1. Remove cylinder head cover. (Refer to 9 – ENGINE/CYLINDER HEAD/CYLI NDER HEAD COVER(S) –                     …

1. Clean valves (4,5) thoroughly. Discard burned, warped and cracked valves. 2. Remove carbon and varnish deposits from inside of valve guides with a reliable…

1. Remove the cylinder head (Refer to 9 – ENGINEI CYLINDER HEAD – REMOVAL). 2. Compress valve springs using Valve Spring Compressor C-3422 (1) and…

REFACING NOTE: Valve seats that are worn or burned can be reworked, provided that correct angle and seat width are maintained. Otherwise the cylinder head…

VALVE GUIDES The valve guides are made of powdered metal and are pressed into the cylinder head. The guides are not replace- able or serviceable,…

CAUTION: Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur. CAUTION: DO NOT allow other , components…

1. Disconnect battery negative cable. 2. Disconnect ignition coil connector (1). 3. Remove ignition coil retaining bolts (3). 4. Remove ignition coil (1). 5. Remove…

1. Clean all surfaces of cylinder block and cylinder heads. 2. Clean cylinder block front and rear gasket surfaces using a suitable solvent. CAUTION: The…

1. Inspect the cylinder head for out-of-flatness , using a straightedge (2) and a feeler gauge (1). If tolerances exceed          0.0508…