CAUTION: Oil pump pressure relief valve and spring should not be removed from the oil pump. If these components are disassembled and or removed from…

NOTE: It is not necessary to remove water pump for timing cover removal. 1. Remove the engine timing cover. Refer to COVER(S), ENGINE TIMING, REMOVAL.…

NOTE: Mopar® Engine RTV must be applied to the 4 T-joints, the area where the front cover, rear retainer and oil pan gasket meet. The…

1. Disconnect the negative battery cable (1). 2. Remove the intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL. 3. Remove the engine oil dipstick and tube…

Change the engine oil at the mileage and time intervals described in the Maintenance Schedules. Refer to MAINTENANCE SCHEDULES, DESCRIPTION . Run the engine until…

On the 6.4L engine, the oil level indicator is located on the right side of the engine. CAUTION: Do not overfill crankcase with engine oil,…

1. Position the piston oil cooler jet (1). 2. Install the piston oil cooler jet retaining bolt and tighten to 13 N.m (10 ft. lbs.)…

1. Remove the oil pan and oil pump pickup tube. Refer to PAN, OIL, REMOVAL. NOTE: It may be necessary to rotate the engine crankshaft…

Four dual-nozzle oil jets are bolted to the cylinder block underneath the main oil gallery. The jets connect with an oil-tight fit to the main…

1. Lightly lubricate the oil filter gasket with clean engine oil. NOTE: Do not over tighten the oil filter. 2. Thread the oil filter (1)…