• Secure the turbocharger actuator wiring away from hot and abrasive parts.

The turbocharger actuator must be calibrated to the turbocharger. This step must be performed to be sure proper turbocharger operation is achieved. With INSITE electronic…

NOTE: Following these instructions in order is very important. • Continue through the entire turbocharger actuator installation procedure before attempting to troubleshoot any     …

Use a clean cloth to wipe around the surface where the turbocharger actuator seals to the turbocharger. NOTE: Take care not to drop any dirt…

Disconnect the wiring harness from the turbocharger actuator by sliding the locking tang to the open position, then push down on the release lever and…

This procedure provides service information tor the electronically controlled variable geometry turbocharger actuator. Take careful note to avoid improper installation of the turbocharger actuator. Installation…

Install the turbocharger compressor outlet connection and o-ring seal. Use a new o-ring seal. Make sure to remove the protective caps. Install the clamp and…

Clean the turbocharger compressor outlet connection with solvent and dry with compressed air. Inspect the turbocharger compressor outlet connection for cracks, damage, or abnormal wear.…

Loosen the clamp holding the turbocharger compressor outlet connection to the turbocharger. Remove the turbocharger compressor outlet connection and seal, taking care not to drop…

Two Piece Air Intake Connection Adapter Install the a-ring seal in the groove of the air intake connection adapter. Install the air intake connection adapter.…