1. Remove the valve covers. See VALVE COVERS. Disconnect the harness connectors from the glow plugs. See Fig. 59. 2. Disengage…
Category: 7.3L Power Stroke
1. Position the fuel injector sleeve onto the Injector Sleeve Replacer (303-D109, D94T-9000-C). Apply Threadlock® 620 to the very bottom (smallest diameter) and…
1. Remove the air cleaner assembly and resonator. Drain the fuel from the cylinder heads. Loosen the drain plugs, located at the rear of each…
1. Remove the fuel filter/water separator assembly. Remove the fuel filter cap and element. See FUEL FILTER/WATER SEPARATOR. 2. Remove the fuel filter heater thermostat…
1. To install, reverse removal procedure using NEW seal ring. Apply diesel fuel to seal ring before installing. Ensure seal ring is…
1. Disconnect negative battery cables. Remove necessary air intake components for access to fuel filter/water separator…
1. Inspect push lock coupling for any internally damaged components before installing. If any internal components are damaged, replace fuel line. 2.…
1. Relieve fuel pressure. See RELIEVING FUEL PRESSURE. Lift retaining clip upward from push lock coupling. See Fig. 46. Push Lock Coupling Remover…
1. Ensure garter spring is installed in cage on spring lock coupling. If garter spring is damaged, replace garter spring. 2. Ensure fuel lines and…
1. Relieve fuel pressure. See RELIEVING FUEL PRESSURE. Remove retaining clip from spring lock coupling. See Fig. 45. DO NOT use…