Install the new pass through connector. Connect the pass through connector to the injector solenoid wires. Insert the pass through into the rocker lever housing.…

The Metri-Pack pass through connectors connect the actuator harness to each of the injector solenoid wires in the rocker lever housing. Disconnect the actuator harness…

Caution: Do not use a hammer or damage to the dowel will result. Use a mallet to install the ring dowels and pin dowels.  

Select the proper size ring dowel remover and insert the threaded end into the ring dowel to be removed. Tighten the hexagon nut until snug.…

Remove the o-rings and discard. Clean the oil manifold connector, external oil manifold, and internal oil tube. Inspect the oil manifold connector for cracks, damage,…

Install two o-rings (1) on each of the two water tubes (2). Install one o-ring (1) on each of the two water plugs (3). Apply…

Visually inspect the housings for cracks or damage, and replace if necessary. Visually inspect the capscrew holes for damaged threads. If threads are damaged, refer…

Steam clean the rocker lever housings. Dry with compressed air. NOTE: Make sure the oil supply hole is free of dirt or other deposits. Do…