Visually inspect for pitting or erosion in the crevice seal groove. Replace the liner if pitting or erosion is greater than one-half the width of…

Remove the crevice seal. Remove the two o-rings. Caution: Do not use a hone, deglazing, or prebrushing to clean the cylinder liners. Abrasives can damage…

Caution: Do not install cup plugs in the block until the cleaning, inspection, and necessary repair procedures are completed. This will prevent dirt from being…

Caution: Do not install straight thread plugs or pipe plugs in the block until cleaning, inspection, and nec- essary repair procedures are completed. This will…

NOTE: Do not install the dowel pins in the block until the inspection and any necessary repair procedures are com- pleted. Caution: Do not use…

Caution: Incorrect installation will block oil flow to the rocker levers and the cam followers resulting in severe damage to the engine. Refer to the…

Due to the complex nature of troubleshooting procedures required for diagnosis and repair of counterbores, this information has been excluded from this manual. Complete counterbore…

Components included in the capscrew thread repair kit, Part No. 3376208, for the N14 block are as follows: Remove any burrs from the top deck…

The coolant passage repair kit, Part No. 3823679, consists of the following components: Sealing and retaining compound is also available in a 250 ml bottle,…

Refer to the Alternative Repair Manual, Bulletin No. 3379035.