Install the oil pan gasket and the oil pan on the cylinder block. Use your fingers to install and tighten one of the 7/16-inch oil…

NOTE: Make sure the pipe plug behind the pulley is installed and tightened before pulley installation. Apply a film of LubriplateT 105 or its equivalent…

Install the oil seal on the fuel pump drive oil seal mandrel, Part No. ST-1173, with the closed or part number side facing the driver.…

Install the support bearing in the bore of the gear cover. Do not install the o-ring on the support at this time. Push the support…

NOTE: ‘‘LDL TFE’’ (Lay-down Lip, Teflon) oil seals for service replacement have an assembly tool which protects the seal lip during shipment and installation. The…

Install one 7/16-20 X 4-inch guide stud in each side of the gear cover mounting flange to align the cover. Install the gear cover gasket…

Install a new gasket on the mounting trunion of the lubricating oil pump. Install the lubricating oil pump in the mounting hole in the cylinder…

Install a new EPS in the mounting hole in the block. Make sure a new o-ring is present and in place. Use service tool, Part…

Rotate the crankshaft until the accessory drive timing marks on the camshaft gear are at approximately the 1:00 o’clock position. Install a new gasket on…

The injection timing is the relative measurement of the distance remaining between the injector plunger and the injector cup when the piston is 5.161 mm…