Install two guide pins into each rocker lever housing. Install new C-Brake housing gaskets and the C-Brakes. Remove the guide pins. Install the C-Brake capscrews.…
Category: Cummins N14
The valve set marks are located on the accessory drive pulley. The marks align with a pointer on the gear cover. Use the accessory drive…
The valve set marks are located on the accessory drive pulley. The marks align with a pointer on the gear cover. Use the accessory drive…
Install the exhaust (1), injector (2), and intake (3) rocker levers onto the shaft. The two levers closest to the center of the rocker housing…
Install the valve crossheads in their original location and orientation. Lubricate the valve stems with clean 15W-40 oil. Use a wire gauge to check the…
Use clean 15W-40 oil to lubricate the ball end of the push tubes. NOTE: The injector push tubes (1) are larger in diameter than the…
Install the oil manifold connector using new o-rings. Lubricate the o-rings and the rocker housing bores with vegetable oil. Also lubricate the internal jumper tube…
NOTE: The N14 engine injector torque value is 54 N•m [40 ft-lb] NOTE: When installing injectors for reuse, new o-rings must be installed on the…
Install two o-rings (1) on each of the two water tubes (2). Install one o-ring (1) on each of the two water plugs (3). Apply…
Use new o-rings, and install the two fuel crossover connections and the two cover plates. Tighten the capscrews. Torque Value: 4.0 N•m [35 in-lb]