Remove the three capscrews from the support. Use a rubber or plastic mallet to rotate the bearing support approximately 60 degrees. Use a suitable pry…

Remove the cam follower housing assemblies as follows: 1. Remove the six capscrews and studs from each cam follower housing. NOTE: Record the position of…

Remove the 12 capscrews and washers from each cylinder head. Lift the cylinder heads from the block, and remove the cylinder head gaskets. Caution: To…

Remove the four capscrews from each of the two fuel crossovers, and remove the fuel crossovers. Remove and discard the four o-rings.

Remove the water manifold tube clamps. Use service tool, Part No. 3823819, to push or pry the adjacent water tubes into the rocker housing cavity.…

CELECTTM Engines Disconnect the injector solenoid leads from the pass through connector in the rocker housing. Remove the injector hold down clamp capscrew. Remove the…

Remove the push tubes. NOTE: To prevent increased wear, mark each push tube as it is removed so it can be installed back in its…

Remove the crossheads. Be sure to mark them appropriately so they can be installed in the same location and orientation during the installation procedure. NOTE:…

Loosen the valve and injector adjusting screw lock nuts on each rocker lever. Turn the adjusting screws counterclockwise until the rocker levers are loose. Remove…

Disconnect the C-Brake harness wire from the electrical connector on each C-Brake housing. Remove the capscrews from each C-Brake housing. Remove the C-Brake housing. Remove…