Remove the water manifold tube clamps. Use service tool, Part No. 3823819, to push or pry the adjacent water tubes into the rocker housing cavity.
For example, the tube between housing No. 1 and No. 2 must be pushed into housing No. 2. The tube between housing No. 2 and No. 3 must be pushed into housing No. 3.
Remove the rocker housing mounting capscrews.
NOTE: To prevent increased wear, mark each rocker lever housing as it is removed so it can be installed back in its original location.
If the rocker housing assemblies are to be installed after rebuild with their original parts, mark each rocker lever housing as it is removed so it can be installed back in its original location thus taking advantage of worn-in mating parts.
Remove the rocker lever housings.
Remove the gaskets.
NOTE: On CELECTTM engines while handling the rocker lever housings, protect the wiring harness pass through connectors. Do not subject the pass through connectors to impact forces and do not rest the housing on the face with the pass through connectors.
