[1] – Remove two check valve caps (A). [2] – Remove check valves. Inspect each check valve face (B) and seat (C) inside valve body…

[1] – Park machine safely. [2] – Operate SCV lever in all positions to relieve any hydraulic pressure. Lower any suspended attachments to ground so…

[1] – Replace two O-rings (A). [2] – Apply a thin bead of Form-in-Place gasket maker to joining surface (B). [3] – Install feedback valve…

[1] – Park machine safely. [2] – Raise rear of machine and remove right rear wheel assembly. Safely support rear axle. [3] – Remove right…

[1] – Insert new rockshaft bushing(s) (A) if removed. Press bushings to a depth (B) of 6.4 mm (0.25 in.) below outer edge of rockshaft…

[1] – Remove snap rings (A) securing lift arms to rockshaft. [2] – Remove locking pin (B) and flat washer securing position feedback rod (if…

IMPORTANT: To avoid interference damage make sure tang rests on housing stop. Before starting rockshaft installation rotate installed clutch assembly so that PTO brake reaction…

[1] – Park machine safely. [2] – Remove seat. (See Remove Seat in Section 90, Group 05.) [3] – Remove left and right closeout panels.…

[1] – →NOTE: Make sure that all O-rings are in place when installing the valve body and hydraulic pipes. Install O-rings at transmission case PTO…

[1] – Park machine safely. [2] – Raise and safely support rear axle. [3] – Remove left rear wheel. [4] – Remove wire harness connector…