[1] – Park machine safely. [2] – Raise rear of machine and remove left rear tire. [3] – Lower machine onto jack stand under left…

[1] – Install bushing assembly (A) into pump body. [2] – Install idler gear (B) and drive gear (C) into pump body. [3] – Install…

→NOTE: Repair parts are not available separately for the hydraulic pump. If any wear or damage is found during inspection, replace hydraulic pump. [1] –…

[1] – Park machine safely. [2] – →NOTE: The transmission holds approximately 12.3 L (3.25 gal.) of oil. Drain transmission oil into a suitable container.…

[1] – Lubricate new O-ring with clean hydraulic oil and install to brake cam shaft (A). [2] – Lubricate housing bore with clean hydraulic oil…

[1] – Remove right-hand rear axle housing and side plate assembly. (See procedure in Section 50, Group 30.) [2] – →NOTE: A shim washer is…

[1] – Remove cotter pins from castle nuts (A) and remove castle nuts. [2] – Using a tie rod end separator, remove tie rod ends…

[1] – Check that O-rings are installed on port fittings. Replace any missing or damaged O-rings. [2] – →NOTE: Unevenly or improperly torquing cap screws…

[1] – Remove the steering wheel. (See Remove and Install Steering Wheel in this Group.) [2] – Remove the control panel. (See Remove Control Panel…

[1] – Install bushings (A) into housing. [2] – Install sector gear into bracket making sure raised area (B) is properly engaged in hole. Install…