1. Remove the release fork (1) mounting screw (2). 2. Draw out the clutch lever (3) to remove the release fork (1). 3. Remove the…

1. Remove the speed change cover (1). (When reassembling) • Apply liquid gasket (Three Bond 1206C or equivalent) to joint face of speed change cover…

1. Check the mid case and transmission case are securely mounted on the disassembling stands. 2. Loosen the remove the transmission case mounting nut. 3.…

1. Remove the front wheel drive case (1) and lever (2). (When reassembling) • Be sure to assemble the gasket. • If gasket is damaged,…

1. Remove the screw (4) then tap out the spring pin (3). 2. Slide the propeller shaft cover 1 (5) to the front and the…

1. Remove the suction pipe (1). 2. Remove the delivery pipe joint screws and the delivery pipe (2). 3. Disconnect the brake rod (R.H.) (3).…

1. Disconnect the ground cable (1). 2. Remove the clamp (2) and wiring (3). 3. Remove the HST pedal (5) and the steps (4), (6).…

1. Disconnect the PTO wire (1). 2. Remove the fender supports (2) and the fender stay (3).

1. Place the disassembling stand under the mid case and the transmission case. 2. Remove the upper frame (1) and the lower frame (2). 3.…

1. Remove the seat (1). 2. Remove the grip (2) and guide (3). 3. Remove the grip (4). 4. Remove the floor sheet cover (5).…