Cummins N14 – CELECT Engine Position Sensor (EPS) – Removal

Disconnect the sensor from the sensor harness. Turn the EPS out of the cylinder block. Use service tool, Part No. 3822747.

Cummins N14 - CELECT Sensor Harness - Removal
Remove the retaining clamps for the sensor harness from the support bracket and the engine…
Cummins N14 - CELECT Coolant Temperature Sensor Location & Removal
Note: The N14 water temperature sensor is directly connected to the thermostat Remove the coolant…
Cummins N14 - CELECT Ambient Air Pressure Sensor - Removal
Remove the sensor mounting capscrews. Remove the sensor from the engine.
Cummins N14 - CELECT Lubricating Oil Pressure Sensor Location & Removal
Note: N14 cummins oil pressure sensor is located bellow the ECM box on the fuel…
Cummins N14 - CELECT Actuator Harness - Removal
Remove the actuator harness clamps from the support bracket. Although the OEM harness is shown,…

Published by samuel